Welcome To Small Scale Innovative
FRA 224 SAFTEY STRIPE INSTRUCTIONS
This instructional guide is used for the following part numbers.
#SS001 - FRA Yellow
#SS002 - Florescent Yellow
#SS003 - Aged Yellow
#SS004 - Group Pack
.jpg)
Each letter (A, B, C) represent each size of stripe.
Letter A - 8" x 18" (End Stripe)
Letter B - 4" x 36" (End Stripe)
Letter C - 4" x 18" (Middle Stripe)
​
Each letter is shown below in the placement diagrams.
Placement Diagrams Per Rail Car
Version 1 - Diagonal Stripe
Version 2 - Vertical Stripe
Stripe A or B can be used for end markings on a flat car, spline car or coil car depending on space and application.
Spacing- 12' maximum space between each center stripe on the rail car (0.1397" in HO Scale 1:87)
How to install
STEP ONE,
Remove each stripe
one at a time with a
pair of tweezers,
utility knife or a
toothpick. Careful
to only pull off
one stripe at a time.
​STEP TWO,
Apply the stripe to
the model in the
desired location.
For best results,
find a smooth
flat surface without
rivets or seems in
the model.
STEP THREE,
Burnish the stripe
using a tooth pick
or similar, careful
not to press too
hard. Do not use
anything metallic
or it may scratch
the model’s surface.
Covering up factory markings
​
Covering up factory markings is
very easy and clean. Just line up the stripe and apply. Also works over decals!
​
Optional Clear Coat Finish
​
To keep the safety stripe in place permanently on
the model, apply a light clear coat finish. This will protect your model and the adhesive stripes.
​
